Product Description
Pro-Bind 2000
The Pro-Bind 2000 is a completely new design from the old Covermate 700 you may be familiar with.
First you will notice two buttons on the Pro-Bind 2000;
one button for soft covers and the
second button for hard covers. The hardcover cycle will automatically adjust the time to a 60 second cycle allowing for full penetration of the heat to fully liquefy the glue in the hardcover books.
When combined with the
Pro-Bind Hard Cover Crimper a perfect hardcover bind is assured every time.
Next change we made in the unit is the position of the electronics and the position of the heater. On the old Covermate 700 the heater board was flat and the circuit board was mounted under the sliding front panel. The new design of the Pro-Bind 2000 has allowed us to mount all electronics to the inside of the front of the binding unit thus keeping it from being constantly jarred and away from the heat source. In addition we have angled toward the back the entire front slide and heating plate 15 degrees. This allows you�re books to remain in a closed position while heating and you end up with a better bind.
The Pro-Bind 2000 has a
2� binding capacity and a
30 second soft cover cycle and a
60 second hardcover cycle. Both units will carry a one year warranty and are
all metal construction and will be
made here in the United States.
Pro-Bind 2000
● All Metal Construction
● No Warm Up Required
● Auto Shut Off
● One Button Operation
● Weighs approx. 10 lbs
● 1/16" to 2" Binding Capacity
● 14.75" Binding Length
● Binds Multiple Documents At One Time
● Circuit Board Mounted on frame away from heating unit
● Cycle Time 30 seconds Soft Cover & 60 seconds for Hard Cover
● 15 Degree Angle on Heating Plate - Allows for less spreading of sheets in binding process
● Factory Set Heat - Fully electronically programmable for changes in paper material or content substraights - 300 to 350 degrees
● One year Warranty