TESTING THE UNIT

Rotate the coin slot dial approximately � turn clockwise on each unit using a quarter or dime until the red LEDs flash. The units are now ready to use. We ship them programmed with a 2.5-minute delay and a hawk scream point signal. Hold the dog's transmitter still with the speaker pointing upward (like it was on the dogs neck) for 8 seconds. You will hear a beep emitting from the receiver. If you leave it still for 2.5 minutes a hawk scream will sound from the dogs transmitter. Shake the dogs unit up and down like a dog running and cycle starts over again. Turn the units off by rotating the dials back � turn counterclockwise or until the LEDs stop flashing.

PROGRAMMING THE UNIT

For battery replacement and access to the programming dip switch, remove the four bottom cover plate screws and remove the cover plate. Remove the battery by pulling on the nylon tape pull-tab. The transmitter switch has 8 positions and the receiver has 4. Switches 1 thru 4 on both units can be any combination of OFF or ON but they must match. If you have a 2-dog unit, the transmitter and both receiver positions 1 thru 4 have to be the same. These are you 16 different ID codes. Switch 5 in the transmitter (dogs unit) adjusts the point beep delay of 2.5 or 5 minutes. Up is 2.5 minutes, down in 5 minutes. Switch 6 is not used. Switch 7 is hawk scream or regular beep point signal. Up is hawk scream and down is just a beep. Switch 8 allows you to totally defeat the point beep. Up is point beep on after the predetermined time, and down is no point beep at any time.